Four disciplines of spray foam engineering consulting
Every engagement is scoped to the project and billed project-based — not per square foot. Below is how each service typically works and who it's built for.
Spec Review & Design Consulting
Independent review of a proposed SPF assembly — R-value target, vapor-retarder class, thermal-bridging mitigation, and code cross-checks — before it goes to permit or gets built.
- Assembly-level R-value verification
- Vapor-retarder class review (Class I/II/III)
- Thermal barrier & ignition barrier code check
Forensic Investigation
Root-cause investigation of a failed or disputed SPF installation — site assessment, likely failure-mode identification, and a written findings report suitable for litigation support.
- Site visit & visual/tactile assessment
- Off-ratio, adhesion, and moisture failure analysis
- Litigation-support-grade documentation
Code-Compliance Consulting
Interpreting and documenting how a proposed or existing SPF installation meets applicable IRC/IBC foam-plastic provisions and state energy-code requirements for your jurisdiction.
- IRC/IBC foam-plastic (Section 316) review
- Energy-code R-value & climate-zone compliance
- Documentation for AHJ submittal
Moisture & Thermal Analysis
Dew-point and vapor-permeability analysis for a specific assembly and climate zone, plus thermal-bridging review and R-value performance verification.
- Assembly-specific dew-point analysis
- Vapor permeability & moisture-drive review
- Thermal bridging identification
Request a spray foam engineering consultation
Tell us about the project — a spec that needs a stamped review, a failed installation that needs a root-cause finding, or a code question that needs a straight answer — and we'll scope the engagement.